@RasPad Support I didn't think anything was holding up behind the screen but I took the pad apart, moved wires, put it back together, and the spot was gone. My temp hdmi cable must have out of...
Today I noticed there is a 5-10mm wide multicolored spot on the touchscreen. If the spot is touched, it changes size, as if there is wet spot between some layer. Anyone know what it could be? I tri...
@RasPad Support OK. I just disconnected and reconnected the the cables that had the touch screen working....and now it doesn't work again. I have no idea what the problem could be. Unless you have ...
@RasPad Support I borrowed a mini hdmi cable (1 meter long) and used it in in place of the long hdmi. The touch screen worked. It looks as though the problem is with the mini hdmi cables that ...
I can't swap and plug-in both cables without damaging either the board on the pad or the raspberry pi. I've tried switching the ends of the cables and it still won't go in without putting too much ...
@RasPad Support I swapped the shorter cable for the longer one and the same results. I couldn't connect the longer cable where the short cable was without damaging my Rasspberry Pi. I figured ...
@Michael Blomquist Thanks. I attempted to route the cables as you had but mine are too short.
@RasPad Support I plugged my mouse into the 3 USB ports on the pad. It worked in all the ports.
@RasPad Support Yes, as plugged as as they will get. Please look at the photo at the beginning of the thread. One of the supplied cables is too short and is pulling on the connections to both board...
Here is a short video showing the pad booting up and then screen not responding to touch. Nothing was attached to the pad (mouse, keyboard, monitor, etc).https://www.dropbox.com/s/od6hk2zgknsil85/I...
No. The "touch" part of the touchscreen doesn't work. I had to hook up a mouse to use the raspad.
I finally got around to putting together my RasPad. The "longer" HDMI cable is too short. It pulls on both boards and lays in the way of a cover connection.
